Raven https://rcsgear.com/surefire-p-and-g...s-pocket-clip/Originally Posted by JCS
Raven https://rcsgear.com/surefire-p-and-g...s-pocket-clip/
Raven Concealment - https://rcsgear.com/surefire-p-and-g...s-pocket-clip/
Edit - didn't see that JOhnny beat me to it.
And those will work on my OG 6P and 3P?
ETA:
Answering my own question, it appears it will work on the 6P but not the 3P, which is ok, but it also appears that you lose the constant on function which I’d prefer to keep.
Anyone know of a clip-on clip option that fits these older lights?
Last edited by rob_s; 05-13-2020 at 06:57 AM.
I have a non surefire light that I’m curious if it will work with. How long is the clip? It’s for a light that’s a cr123 single cell
"Shooting is 90% mental. The rest is in your head." -Nils
I’m bummed to post this because I really want to like this light.
The M61 Hot MD2 18650 that I keep at the bedside failed to work last night. Fortunately the was only a sick dog that really needed to go out at 2am.
The light flickered and died, even though the battery was charged.
This morning I discovered that the brass LED module had come loose inside the head, by backing out in its threads. This requires a special two-pin tool to tighten. I like the modularity of these lights, but this isn’t a good thing to happen in a life-safety device.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
'Special' tool is a bit of a stretch. A regular pair of snap ring pliers will do the trick. Put a dab of thread locker on the retaining ring and the issue should not occur again.
You don't even need snap ring pliers, you can use any regular long-nose plier. Perhaps most relevant, the plier tips on any normal multitool work fine. Just apply pressure inward while turning.
Yes, this is exactly what I use.
Clean the threads (head and ring) with alcohol and use a dab of blue thread locker.
I apparently got the wrong "mcclicky" somehow. The one I got doesn't fit in my 6P correctly, it's too small.
This is what I got (which is way too small a diameter)
https://darksucks.com/products/mccli...b3af3bfb&_ss=r
This appears to be what I need
https://www.oveready.com/flashlight/...z41-p-c-z-g-x/
based on this guy's install video
When you read this entire thread and realize that you must have the M91T but just can’t decide between the MD3 and the MD4…
Reply With Quote