Good afternoon,
I snagged one of the .22 top-end conversion kits earlier this year. I have it on an old Vertec frame, and it runs like a champ!
https://www.berettausa.com/en-us/ber...10-round-mag-/
I would like to change it over to a set of G decocker levers, so it matches my other two Vertecs.
Is this possible? If It's going to be unsafe or cause accelerated wear, I will obviously leave the original levers in place.
As an FYI, I swapped out the factory barrel for a threaded Beretta .22 barrel. It makes for a very sweet suppressed sub-caliber trainer.
https://www.berettausa.com/en-us/ber...readed-barrel/
Thanks in advance for any insight that is offered.