Well, since you like it, here is a Full Monty pic of the bench porn:
Yes exactly, here is a pic from the bottom showing some of them:
Trying to remember exactly, but I think I positioned one of the boards so the rear mounting bolts of the press would screw into the center of it, then built around that. I lag bolted the dogshit out of it, I expected to kill my cheap Black & Decker impact screwdriver (I used a 1/4" adapter, it would have been smarter to get a 7/16" nut driver bit) but it cruised through it and is still kicking. Drill some pilot holes because the driver will break the bolt if you do not (yeah, I speak from experience...). I used a simple spade drill bit to create countersunk holes where the boards need to be flush.