@ GJM,
What finish did you go with for your slide refinish from Primary Machine, I'm going to send a slide in to get milled for a Holosun.
Thanks
Steve
I had Wolff mill a g45 slide, they don’t mill in the posts, but it’s a sung fit for the optic.
Sent from my iPhone using Tapatalk
Sending off a G45 slide tomorrow to CHPWS for RMR cut and Zev posts. Excited to see the finished product.
507 direct mill with primary machine on a G45, standard height sights visible or must use suppressor height? Don't care if it's bottom 1/5, as long as usable.
Sorta around sometimes for some of your shitty mod needs.
507c will require suppressor height sights, 507k may allow for standard sights depending on how deep PM mills the slide.
I would strongly recommend finding the lowest possible BUIS. I want the bottom of the trough level with, or slightly below the top of the optic body. I think the Ameriglo's trapezoidal rear sight obscures the least.
David S.
For those sending slides to CHPWS, be prepared to wait longer than quoted.