My dad has a P220 he purchased back in the ‘80’s when his department transitioned to them from revolvers. It’s a folded slide, internal extractor, original grooved trigger, etc.
The DA trigger has an issue. Without a magazine in the pistol it’s fine. With a magazine in the pistol there is a very heavy hitch in the trigger right before it breaks. The magazine feels like it moves a little bit as the trigger is pressed.
I assume there is some interference with the trigger bar but I’m not sure what is causing it. Trying to figure out what my course of action should be.
It’s not a high round count gun. Somewhere in the neighborhood of 5k rounds. Recoil spring was replaced recently, locking block was replaced at some point, same with pins in the slide. Dad was a Sig armorer and he did all the scheduled maintenance on his IOP and issued P220 but that was years ago.
Thanks in advance.
@LSP552
@taadski