You didn’t I mis read your post. Bleed over from the other thread
The best info I have found on these has been at AFCOM and the consensus there is Diversified Machine was the “A” solution. Last time I looked DM had stopped taking orders to catch up on back orders.
There is also a Form 1 suppressor group on Facebook but there is a lot of bad info and III% / “Boogaloo” crap mixed in there as well.
Last edited by HCM; 06-19-2019 at 12:54 PM.
Legally, they are merely raw materials until are until they are drilled out.
From a realistic POV, People may want to build a a good quality form 1 suppressor, like from diversified machine’s kits or thy may want a suppressor just good enough work for a year until their factory can’s form 4 is approved.
Dropping $200 on form 1ing and oil filter is impractical as it is a disposable item but until it is drilled out, it’s an oil filter.
Are they not? A part is legally a "silencer" if it is "any combination of parts, designed or redesigned, and intended for use in assembling or fabricating a firearm silencer or firearm muffler, and any part intended only for use in such assembly or fabrication." I would never advise someone that they could come into possession of one of those kits before having a completed Form 1.
This isn't legal advice and no attorney-client relationship is expressed or implied by this post.
Whats the advantage of pursuing this route? Is it much faster than a store bought? Or is it to save money?