Don't get me started on that. The .32 snub is an itch that I'm going to have to scratch eventually. I've been looking for some 332s, 432s, and a 632 Pro for a couple years now and every time they come up for sale I haven't been in a position to make it happen. It'll be a good thing when I snag a couple as my coworkers at the office are probably tired of me pontificating on .32 Magnums and .32ACP mouse guns.
"If you think it's expensive to hire a professional to do the job, wait until you hire an amateur."
Disclaimer: I have previously worked in the firearms industry as an engineer. Thoughts and opinions expressed here are mine alone and not those of my prior employers.
It made me regret selling my pre-lock 332 32 H&R...
Using wadcutters for defense in .38 Spl revolvers has been discussed in the gun literature for many decades. I remember reading such in the early 1960's, and I feel certain that the idea developed as soon as did the wadcutter design itself. Some agreed that it was a good idea; others disagreed. Thinking about the idea and reflecting on Doc's opinion, I have a suggestion that may be original. Anyway, I've not seen such reported. My idea is having a custom mold maker create this design: a wadcutter bullet with two or three sharp cutting edges on the front end. For a custom mould maker this design would be most simple to make. The bullet then would, when spinning, saw its way through tissue. I have a sinful amount of lead, the equipment, and about 50 years experience casting bullets. Hmmm .
I saw some pics here also, I just used the corner bend of a jug, started cutting around the shape of my gun, left tabs to fold over so the tape isnt the only thing holding the edge together and the barrel doesnt end up in tape goo. I left the top low enough I can get my hand on the gun correctly, with a slight high spot at the top front above the hammer, it can help catch on the pocket to help the gun clear, i seem to push off on it to help free the gun sometimes.
Somebody else had good info about the milk jug holsters, Im a rank amateur at it. Best thing is its cheap to re-do as needed. I found myself shopping for milk with jugs that didnt have the round indentations in the middle of the flats.
If you dont get milk in gallon jugs, you can get water in gallon jugs at walmarts or other places pretty cheap.
Last edited by Malamute; 06-16-2019 at 01:07 PM.
100%. And it was with Cirillo's input, to the best of my knowledge, that Fuzzy Fletcher made and sold the SafeStop rounds.
I don't have any of the notched rounds, but the plated wadcutters Mr. Fletcher loaded have a sharp ogive to them. They are described and discussed in Mr.Cirillo's excellent book "Guns, Bullets, and Gunfights".
He explains that that shape should preform a cutting action as the bullet passes through the incredibly elastic tissue of the human body, and cut into such bone as the skull is comprised of lessening the chance of it glancing off when struck at an angle.
I've used "one" for front pocket carry for over ten years. And by "one" I mean when the sticky stuff on the outside gets worn smooth, I hit the "buy now" button on 'zon and have a new one in two days.
It seems like the material has changed though, and it's lasting longer.
I was into 10mm Auto before it sold out and went mainstream, but these days I'm here for the revolver and epidemiology information.