I'm happy with my G43 plus gadget.
For a user who wanted G43 size TDA would the PX4 subcompact converted to decocker only with this kit https://www.langdontactical.com/px4-...cocking-lever/ be the best option, in current production? I can tell the slide is wide but I haven't handled one, is it reasonably slim through the grip or is it G26 width?
Last edited by John10-19; 11-17-2018 at 09:19 PM.
I don't know about decocker only. That would be nice if you could set it up that way.
I have '74 German PPK/S--.380. It's been reliable with both hollowpoints and FMJ, with some caveats:
-I had an FTF when it was loaded to 7+1. Never had an issue with a non-topped off mag. Walther Forum research seemed to suggest one shouldn't trust PPKs with a +1 loadout. I dunno.
-Every magazine--except the one that came with the gun--falls out of the gun when shooting. I think it might have something to do with the mag catch.
So, I'm not really carrying it now. If I could get the mag issue sorted out, I might. But it kinda sucks if you can't run +1. My Sig P230 has no such issues. Though I will say I shoot the Walther better. It really is an exceptional shooter--especially with Nill grips, which help redirect some of that nasty blowback recoil. I would anticipate that a lot of these quirks wouldn't be a thing with a newer production PPK. Plus, you get a drop safety with the S&W version.
I had a PP in .32... er 7.65. And learned that .32 and 7.65 are, in fact, different. The extraction groove has a different contour on the 7.65 (European) ammo. So, I noticed my PP ran PPU okay but choked on Winchester .32. Maybe that's not the case for all 7.65 Walthers, but that was my experience. I didn't mess with it much after that and sold it. The recoil was much nicer on the 7.65 though.
Last edited by MattyD380; 11-17-2018 at 09:27 PM.
The way the xde safety works, it's almost a decocker only. Down to decock, all the way up to put on safe. You've got to move it up there, otherwise, it's not on.
Mine's been fine, runs fine (probably only 500 rounds). I just haven't really warmed to it. The DA pull is really too far of a reach for my hand, so I really haven't shot it lately. Quite a bit further reach to the trigger than my j-frame. Combined with a little arthritis/inflamation in my trigger finger joint, it's sort of sat in the safe. But it's not a bad gun really.
Last edited by idahojess; 11-17-2018 at 09:49 PM.
No to decock only. No where for a return spring to be mounted without milling
I dunno which is more reliable, honestly. But the .380 PPK is the only actual PPK (short frame) gun currently in production. So that’s probably what I would do, but what I would do then is send it to C&S for reliability and customizing.
Nothing so needs reforming as other people's habits - Mark Twain
Tact is the knack of making a point without making an enemy / Where is the wisdom we have lost in knowledge?