I bumped this thread to see if anyone has any updates on their AOS system.
I dislike the whole Agency Arms cheesy brotherhood and gimmicks but the AOS mounting system does seem to have some merit. I especially like that the optic plate is machined you your optic.
Was bummed to find that the AOS RMR plate requires modification to work with the 508T. Not really a fault of the AOS as the Holosun screws sit at a different height. Yes ground down the posts and screws a bit and it seems to work.
Other than that, no problem with my AOS G19X slide.
Oh they inexplicably discontinued black screws for the plates and optics! Now only available in stupid colors! WTF
Black torx screws available from the Internet but have to be cut to length.
I had the same reaction when I opened my package and found bright blue screws. What uniform does Agency think they work with other than IPSC spandex? I'm grateful a friend had gone through the pain of figuring out which black screws to buy and what length to cut them to.
Agency if you are watching. You make a great product then go add a massive FAIL right at the end. What were you thinking in the meeting when you made this call?
Last edited by underhook; 11-23-2019 at 12:37 PM.
I have an AOS cut on a g19.4. Ive got about 3k on in in the last few months including a two day LAV class. So far so good. My only complaint is with Agency directly. They had my slide for over 4 months. The slide refinish was messed up causing a huge delay. I like the concept and this mounting system is very solid, but the next gun I have work on will be from somewhere else, more than likely primary machine.
Waiting to receive my slide back from agency. Definitely taking longer than anticipated - they are blaming the DLC refinisher...
The slide has been with agency since early September.