He used to do 686’s.
https://pistol-forum.com/showthread....p-W-686-4-quot
It was that thread that made me go JM for my 3” GP100.
Last edited by Lon; 09-24-2018 at 11:39 PM.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
I have a JMCK for my GP100 Wiley Clapp, my new (to me) 686+ PC fits in there pretty well. Mine was ordered three years ago before the 3” GP100 was a listed option.
The broken edges of the hammer on the PC help with the gut-poke a bit where the Ruger’s hammer is very sharp. Looking back I should have ordered the holster with a higher cut.
Despite the cylinder mass and weight, appendix carry of a short-barreled revolver conceals surprisingly well.
Oops, wrong place, disregard.
Last edited by revchuck38; 09-25-2018 at 12:30 PM.
Hey guys, I just checked with my CNC mold guy to see if he has an L Frame (up to 4" barrel) that will fit un-futted cylinders and the 7 shooter. For whatever reason, I have been getting asked about the L frame quite a bit lately so there may be enough interest to warrant the cost. And of course I may have to buy one for test fitting
Stand by.
Last edited by Tony Mayer; 09-27-2018 at 08:21 PM.
sales@jmcustomkydex.com
And he just emailed back, negative....at this time.......but he is going to try and find one to scan. So that's a big fat maybe!
sales@jmcustomkydex.com