Thanks JBP55!
Thanks JBP55!
Functionally the Gen5 trigger is the same as the 19X. Same trigger housing, connector, trigger spring assembly, trigger bar. Different spring cups and ejector. And the G19X ejector is also standard in the Gen5 26 and 34.
My experience is that the consistency of trigger pull has improved a lot over the years. Tighter tolerances among parts. Improved coatings, etc.
CDFlll thanks for the chuckle.
Sent from my iPad using Tapatalk
Last edited by JHC; 10-04-2018 at 08:08 AM.
“Remember, being healthy is basically just dying as slowly as possible,” Ricky Gervais
There was a thread, on ARFcom of all places, where a poster tested 3 or 4 different ejectors. This included the newest iteration. His conclusion was that the newest version gave him closer to 90 degree ejection, more uniform, and with no BTF. I believe this thread was early last summer.
Just picked up a Gen 5 17 MOS. it has the 47021 ejector.
I put the G19x trigger housing/ejector assy p/n 47208 in an otherwise stock G17G5. I just function tested it including 1911 no magazine testing. I used 147 HST and 115 Sellier & Bellot brass range ammo (asked for the weakest).
Doing 1911 test (no magazine firing) I tried everything from normal shooting to two finger limp grip WHO with both rounds and could not create a stoppage or (fall out the) magwell ejection. Also, magazines with the two rounds randomly interleaved fed and functioned normally. Ejection was straight out the side and the angle didn't change noticeably with different grip strengths, just the ejection distance. Weak WHO ejection was still at least 3 feet.