Glock 19-5 direct milled for a Holosun 507c. Shot a single FAST as a demo in front of coworkers during quals. Managed a 6.40 clean. Not too shabby considering I barely shoot anymore outside of quals with life just getting in the way. We had fewer people than expected show up so we finished early and I was able to do some of my own shooting once quals and training were done for the day. I managed a 98 on the Old Bakersfield PD qual. I lost a point for one shot just outside of the 8 ring of a B8 at the 10 ft stage and another for going overtime at the 20 ft stage with a time of 2.01. Then a little pressure at distance. Defoor Hat Qual was a fail 80/100 in 14.59. I shanked one completely off the 8.5”x11” B8 printout so I lost 10 points going into it. I tried the Presscheck No Fail Shot and came the closest I’ve ever come to passing. Only 5/10 in the black but all my misses were close. Nothing left the 8 ring. Most of the reps were around 2.6s or so. I need to throttle it back a little bit and use another quarter to half second or so per shot to clean things up. Next I tried to push some concealed draw speed up close and that’s where things went wrong. I had several draws at 3y of 1.05s, 1.01s, etc. I decided to really hit the gas because I’ve never been able to pull off a sub-second draw. Well, I managed a 0.99s that did hit the 8.5”x11” paper. The bad news is I had a terrible strong hand grip and my thumb was in a bad spot. The slide took a chunk of skin off my thumb about the diameter of a pea. I bled like a stuck pig for a bit and decided to call it a day. I’ll ask one of the other instructors to shoot the demo tomorrow because my hand hurts.