Didn't get enough photos, but I zeroed 5 pistols with red dots today. 3 RMRs (Glock 19, 17, 26), a 507k (glock 43), and a 507c (Aimsurplus slide that is my dedicated suppressor host).
They definitely make precision at long range rather easy.
Didn't get enough photos, but I zeroed 5 pistols with red dots today. 3 RMRs (Glock 19, 17, 26), a 507k (glock 43), and a 507c (Aimsurplus slide that is my dedicated suppressor host).
They definitely make precision at long range rather easy.
Last edited by Nephrology; 06-21-2021 at 02:54 PM.
P2000sk v2
10 yards
5 rounds each, LHO / RHO, scored 49-1x, 49-2x
Taking a break from social media.
Dryfire day at my desk, a few hundred cycles with the new P320 X5 Legion since I have the house to myself. I thoroughly burned down the street lamp across the drive doing so…
Ken
BBI: ...”you better not forget the safe word because shit's about to get weird”...
revchuck38: ...”mo' ammo is mo' betta' unless you're swimming or on fire.”
10 years, two different LCP Gen1s and no issues. Finally happened today.
After the first few dozen rounds I started having FTE. Sometimes last round would remained in the chamber after firing. Then had double feeds on top of that. Also gun would not go fully into battery even when empty.
I’ll admit the gun is very dirty and needs to be cleaned, but even in that condition it always worked before. I’ll clean it and try it again.
Took the new P320 X5 Legion to the local range yesterday and shot a sizable portion of my retirement*. This was the first time I’ve shot here in NH, I’m glad that this range seems good. The gun performed fine and was both accurate and enjoyable.
*100 rounds of Lawman 124 from the stash. They had range 115s available for obscene pricing.
Ken
BBI: ...”you better not forget the safe word because shit's about to get weird”...
revchuck38: ...”mo' ammo is mo' betta' unless you're swimming or on fire.”
I put together my PX4 and Holosun 507c and also installed the Dawson .145 rear and Night Fision orange front sights on my first P99C and took them to the range to zero them. I used some of my remaining 125-grain LSWCs to get close to zero because they make nice, easy-to-see holes, and my carry ammo (124-grain +P HST) for verification. This was my first experience with a red dot sight and it was weird, I need to get used to it. Using three-shot groups, it took six tries (four with handloads, two with HST) to get the PX4 dialed. When I fit the rear sight to the Walther, I centered it with my calibrated eyeball as well as I could. The first two shots literally took out the X on the B8. The HST was right in there too. I backed out the set screw, hit it with a drop of blue Loctite, and tightened it.