Ok- question of the week....I know, I know....
I haven't used case lube in the past- but have been reading- how case lube needs to be used, which is good. No reason I hadn't used it in the past, but since it really seems needed and I want to be a knowledgeable reloader- figured, time to start using case lube.
So- sprayed it on the brass, rolled the brass around, waited a few minutes and cranked up the 650.
I always like to check my first few powder tosses and they were a bit light- which isn't typical. What I noticed is that not all the powder is coming out of the brass- some is staying stuck to the inside of the sides of the brass. Obviously- this will throw off my weight to the low side.
My assumption is that I probably didn't wait long enough for the brass to dry from the case lube- so I am going to eat dinner and try again in 30 minutes.
Do you use case lube? And- have you noticed something like this in the past? I am off by about 0.3 grains- which seems like its sticking.
I really appreciate all the patience you guys are showing- and unless you want to come visit for the weekend- I don't have many other ways to learn other than YouTube (shudder).
Thanks again and sorry.