Aimpoint just dropped ACRO P-1 MRDS!

[HeavyDuty]

According to Doug on Facebook, the ARCO can be mounted low enough to co-witness with standard size sights and the cut will be cheaper than a RMR cut.

Woah! No suppressor height sights?

[Xhado]

Woah! No suppressor height sights?

It makes sense since you no longer need to screws threading into the slide you can cut it as low as possible.

Smaller height over bore and less optic above the slide.

[JodyH]

I'm going to experiment with one on my CZ Scorpion, and see how it does.

I'll probably try one on my Glock-a-Roni.

I'm not jumping on the pistol slide mounted ACRO train until GJM breaks a couple of them first.

[Jay Cunningham]

I'm not jumping on the pistol slide mounted ACRO train until GJM breaks a couple of them first.

Wisdom.

[Rex G]

I'm not jumping on the pistol slide mounted ACRO train until GJM breaks a couple of them first.

I may settle for “until GJM tries, and fails, to break a couple of them.”

[sharps54]

I'm going to order a Gen5 G19 MOS and just run it with irons (like my Gen4) until these are vetted.

[GJM]

I'm going to order a Gen5 G19 MOS and just run it with irons (like my Gen4) until these are vetted.

The problem is that you can’t just mount a PMO and expect to be able to shoot it well, as there is a significant learning curve.

[sharps54]

The problem is that you can’t just mount a PMO and expect to be able to shoot it well, as there is a significant learning curve.

Understood but a PMO is a good chunk of change starting with a pistol to mount it on. One step at a time.

Actually I might splurge on a Deltapoint Pro to start learning on. I have a .44 Redhawk project I could use it on down the road using an EGW or Raptor Engineering rear sight mount. I assume the DPP shouldn't have the same issues in a revolver and the battery life won't matter as much on a hunting gun a couple weekends a year.

[GJM]

Understood but a PMO is a good chunk of change starting with a pistol to mount it on. One step at a time.

Actually I might splurge on a Deltapoint Pro to start learning on. I have a .44 Redhawk project I could use it on down the road using an EGW or Raptor Engineering rear sight mount...

Hopefully that sits lower than the EGW dovetail mount I tried yesterday on a VP9 with a Pro.



I bet there is a G45 MOS by NRA if that influences your decision making.

[sharps54]

Hopefully that sits lower than the EGW dovetail mount I tried yesterday on a VP9 with a Pro.



I bet there is a G45 MOS by NRA if that influences your decision making.

I'll definitely go MOS or milling on a Glock but I'm not sure if a better option then the EGW / Raptor for a revolver, I'm open to suggestions...