HK P2000 LEM spring questions

[EricP]

Can anybody verify the part numbers to convert a 2003 vintage P2000 V2 to a Todd Green Special as:

P.N. 214192 Old Style Firing Pin Block Spring
P.N. 214300 Hammer Spring

Thanks!

[Shapap]

Sorry did not see this thread till now. I recently did TGS on my AC code P2000 and used the 'new style' firing pin block spring (#209296 ) and the hammer spring you listed. It works just fine and I don't seem to be getting any light hits on the primer. I think that 'old style' firing pin block spring is just for pre 2005 USPs that need to be upgraded to use the revised parts. I was confused a little at first and thought I needed the older parts, but with a ton of searching I came across a thread (that I can't seem to find again, sorry ) where a CS rep for HK said that all the updated parts were already on all P2000 series pistols.

I can't quote that directly obviously since my memory is a little fuzzy, but for what its worth the new style FPBS works on mine with no problems, it has about 1k rounds since conversion. Hope that helps!