Last edited by Clusterfrack; 04-20-2018 at 01:13 PM.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
I just spoke to the guy who worked on my Bisley. He mentioned small areas can become to brittle and chip, so maybe safer not exposing the threads on the barrel and frame.
Those are some very warm loads. It is amazing that the Buffalo Bore load generates that velocity out of a 3 3/4" barrel I think I remember Jeff Quinn shooting some out of a Bisley in his video review.
My loads that I am going to chrono tomorrow are quite mild, especially compared to those loads. They will only be about 980 to 1000 fps out of the Bisley and 1150 to 1180 out of my Henry Big Boy with a MBC 240gr coated HC RNFP.
Last edited by DAVIDF; 04-20-2018 at 01:26 PM.
May I inquire as to turnaround time?
It was about 5 weeks.
I don't know for sure. Charter Arms now nitride treats some of their revolvers. A number of parts can't be treated such as springs and the trigger. The springs won't withstand the heat and the sear will be too brittle.
I'll find out over time as this is my most heavily used handgun.
Yeah, I wonder about the heat relaxing the tension on the barrel threads.
http://www.customar15.net/ar-15-faq/...barrels-equal/
http://www.m4carbine.net/showthread....treated-barrel
.
-----------------------------------------
Not another dime.