Picked up a set of Pachmayr/Lyman’s for my Ruger. A bit bigger profile than the rubber factory stocks, but they feel good. Need to shoot and carry them for a final verdict. Attachment 26316
I got these off of EBay, from a seller in Thailand. They’re actually nice. I didn’t want to spend too much money on these stocks for this revolver (they were $35). It cost me $100 for the gun and I used it to foil a carjacking. So I want it to remain in its present condition, just easier to hold onto.
civiliandefender.com
Finally got the SW039 Nill Grips... They feel amazing. They are larger than I thought they would be, but they fit so well they snap together. They almost don't work with safari land comp IIs. Even though I have smaller hands it makes the gun sit perfectly in my hand for trigger reach. I just recently picked up this 13-3 factory 3 incher. I saved the original hammer and picked up a new one and bobbed it myself (yeah I realize it could look better). I should be able to shoot it with the new grips soon.
Bear Hug grips in tulipwood shown on a 28-2. I sure wish I could run across some more of these grips.
Last edited by LOBO; 06-03-2018 at 04:49 AM.
Those are the “skeeter” grips. BluMagnum makes them now.
https://www.blu-magnum.com
Thanks for the info HCM. I knew they were Bear Hug grips, but I was unaware that they were the Skeeter grips.
I'll have to check into getting some grips from BluMagnum. Maybe some birdseye maple for a 66 no dash