Thanks again, Tom.
Thanks again, Tom.
We wish to thank the United Network Command for Law and Enforcement, without whose assistance this program would not have been possible.
I can’t recall who recommended it in a previous thread but a 5 minute “pre wash” with just hot water will do wonders to get the big stuff off the cases before you put the soap/lemishine in for the long wash.
A 5 minute pre wash, followed by a 1 hour Dawn/Lemishine wash with fresh, hot water (no pins) makes my brass look cleaner and brighter than hours of vibratory cleaning.
Sent from my iPhone using Tapatalk
I dropped mine off at a friends bourse who doubted me, and swore his vibratory tumbler can’t be beat (small Dillon). He had approximately 4-5000 cases to clean, which he estimated would take 8-10 cycles.
He tumbled a load for 4 hours, then we loaded up the fart and ran it for 30 minutes. The brass came out cleaner than what he had been doing. All of his cases are cleaned after 2 cycles with the fart as well.
Sent from my iPhone using Tapatalk
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
After going to wet tumbling, I'll never go back to a vibratory tumbler.. it's faster, cleaner, and gives better results.. Besides after going through 2 large Dillon tumblers (motors burnt out in both) I'm convinced that the vibratory tumblers are designed to fail after a bit of useage, forcing you to buy another. I mean, look at how they all work, the motor is bolted to the bottom of the bowl, at the other end of the motor is a weight bolted to the motor's shaft which causes the vibration when it's running, it's also putting alot of stress on the shafts bearings. In the case if the Dillon tumblers, I took the motor from mine and went to a local motor repair shop to see if it could be rebuilt, nope, it was shot, they tried to order a new one as it was made by Emerson Electric. Emerson told them that, that motor was proprietary, made and sold to one customer..Dillion.. Dillon wanted $110 plus shipping to "rebuild" one of mine, I figured if I went that route, I'd be better off buying a new one, so that's when I decided to give wet tumbling a try.. Best move I ever made.. the wore out dillion tumblers are going out in the trash..
Last edited by ralph; 03-29-2018 at 02:40 PM.
Don't know how or where (probably FB...), but I tripped over some link that informed me that an intended use of Lemi Shine/citric acid is eliminating chalky white residue in the dishwasher, typically associated with hard water. Tried it and it works great, pleasing the cohabitant a great deal, who had been grumbling about us needing a new dishwasher. Since this is a technical sub forum, I am posting cause I figure many other members probably have well water like we do.
In related news, a few weeks ago she wanted to wash her car and asked me "What soap have you been using to wash the cars?"
Last edited by mmc45414; 07-22-2018 at 08:39 AM.
Long time reloader here. Long time tumbler. If I go to the FART, tell m about "drying" the brass. Thanks
Food dehydrator. By far the smartest and easiest solution.
https://www.amazon.com/Presto-06300-...ood+dehydrator
#RESIST