-
Member
Walther PPS Classic .9mm .40S&W parts swap.
Hi, just curious as to which upper/lower parts are/are not exchangeable between the Classic 9 & 40 in case of the need for emergency cannibalization at some point. My guess would be 'not' on the extractor/ejector/recoil spring, and? I don't have part no. diagrams handy. Anyone very familiar with the internals of these?
Thanks,
Dave
-
Member
Ok, I found this parts guide which is similar to what I was looking for from Walther but couldn't locate.
https://www.gunpartscorp.com/Manufac...484.htm?page=1
(no affiliation with the company above)
According to that page, aside from the obvious barrel/slide, apparently the only part not interchangeable is the extractor. Kinda surprising that it appears they use the identical guide rod/spring assembly. I noticed that they look the same (no visual difference or id markings on the spring), but figured that the .40 would be a bit heavier.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules