Our cyber bullying thread

[GuanoLoco]

I would encourage Pistol-Forum to adopt a stance of gender- and orientation-inclusive derogatory terminology, just to keep up with the times. I propose #poorshitbag , #poorfuckwit , #poorasshat , or perhaps #incomedisadvantagedoxygenthief .

I think it's important we all be offended equally.

Doodie already figured it out. Anyone who loads on anything less than a fully automated 1050 is a peasant.

Sadly, the bar has been raised again. Anyone not reloading on Mark 7 Revolution is also a peasant.

The only good news is that I don't know anyone with a Revolution. Yet.

[voodoo_man]

And here I thought this was a legit thread about cyber bullying...

#fakenews #clickbait

[hiro]

The only good news is that I don't know anyone with a Revolution. Yet.

I guess I should just google this but, what's the legal side of selling ammo? Do you need permits, a license?

[LittleLebowski]

Doodie already figured it out. Anyone who loads on anything less than a fully automated 1050 is a peasant.

Sadly, the bar has been raised again. Anyone not reloading on Mark 7 Revolution is also a peasant.

The only good news is that I don't know anyone with a Revolution. Yet.

#Peasant

[LittleLebowski]

I have a 650 and don't have a case feed, bullet feed, primer feed, or dog feed. Elitist asshole!

[LittleLebowski]

Doodie already figured it out. Anyone who loads on anything less than a fully automated 1050 is a peasant.

Sadly, the bar has been raised again. Anyone not reloading on Mark 7 Revolution is also a peasant.

The only good news is that I don't know anyone with a Revolution. Yet.

#Pauper

[Chance]

I guess I should just google this but, what's the legal side of selling ammo? Do you need permits, a license?

I don't pretend to understand ATF, but according to this, yes.

[LSP552]

I feel like I'm being bullied into upgrading from a 550 now....

[Matt O]

I don't pretend to understand ATF, but according to this, yes.

Not to mention the liability aspect.

[LittleLebowski]

Having fun figuring this stupid problem out. My case feeder doesn't clear my cabinets mounted overhead. So, I can either cut out part of the cabinet to make it clear, or extend out the bench using melamine sheet, 3/4" plywood sheets, 2x6s, whatever. Yes, I know it's mounted backward in the pic, showing how much room I had with my existing setup flush with the front of the reloading bench.

HALP.