This G4 G19 has ~1000 rounds through it and it looks like this:
Meanwhile, the other one, that has ~2000 looks like this:
Sent from my Pixel XL using Tapatalk
This G4 G19 has ~1000 rounds through it and it looks like this:
Meanwhile, the other one, that has ~2000 looks like this:
Sent from my Pixel XL using Tapatalk
Fairness leads to extinction much faster than harsh parameters.
On my G4 G19 the edges of the plunger were sharp, and appeared to be causing a burr to form on the trigger bar where it scraped the top edge. I rounded off the edges of the plunger and cleaned up the trigger bar, and have had no more issues.
I would think the plunger should look more like this: https://store.apextactical.com/WebDi...Details/192006
Seems a bit ridiculous to have to clean up or swap a plunger in ~1000 rounds, no?Originally Posted by peterb
Sent from my Pixel XL using Tapatalk
Fairness leads to extinction much faster than harsh parameters.
I was not impressed. Looked like very sloppy machining work. The chamfer was tiny and the edges hadn't been rounded at all.
But I just wasn't in the mood to fight with Glock about it.
Last edited by peterb; 03-14-2017 at 06:10 PM.
Looks fine.
If it's really bothering you replace it. It's not expensive.
VDMSR.com
Chief Developer for V Development Group
Everything I post I do so as a private individual who is not representing any company or organization.
Ok. Just looked rough but couldn't feel anything. G2G
Sent from my Pixel XL using Tapatalk
Fairness leads to extinction much faster than harsh parameters.
Perfectly normal. The nickel/Teflon plating tends to flake of of the small parts, especially the plunger. Glock will tell you it is not an issue. All of mine look like that. Using a harsh cleaner like Hoppe's can make it really bad. It can peel off the striker and trigger bar as well, but this seems to be rare compared to the plunger.
Some of mine look better than others. I have one or two pistols with Apex safety plungers and they seem to be holding up very well.
Sent from my Moto G Play using Tapatalk
Reply With Quote