Just a Hairy Special Snowflake supply clerk with no field experience, shooting an Asymetric carbine as a Try Hard. Snarky and easily butt hurt. Favorite animal is the Cape Buffalo....likely indicative of a personality disorder.
"If I had a grandpa, he would look like Delbert Belton".
(Formerly known as Sotex.)
I have both a 3" and a 4" CS-1. I bought the 4" years ago, when the contract overrun guns were getting out to the dealers. I was at the OGCA and ran into Ken Hackathorn. Ken took me to a dealer's table who had both barrel lengths. I ended up buying a 4". It has been a great revolver. No issues at all. I then go the 3" from an ad on the forum a couple years ago. I haven't shot the 3" much, but it seems fine.
Congrats on the great find, TC!
Last edited by psalms144.1; 01-10-2017 at 01:43 PM.
My pair of CS-1s. I don't know why I didn't get a three inch too.
Well, my new revolver arrived at my FFL last night and I picked it up this morning. It's in very nice shape. A little bit of holster wear, and a heavy turn line, nut that's about it. The DA trigger is probably the best I've had on an L-frame. Not as good as the old N-frames I've had, but still good. I'm not sure how I feel about the all black front sight, but I'm going to leave it stock. I'm looking forward to shooting it-- The 3" barrel feels just right, so far.