Ruger LCR?

[Willard]

Yes; yes you do.




Sent from my iPhone using Tapatalk

What type of snap caps are those? Might need to pick up some to replace my A-Zooms. Thanks.

[RJ]

What type of snap caps are those? Might need to pick up some to replace my A-Zooms. Thanks.

I believe it was these:

ST Action Pro - .38 Spl Action Trainer Dummy Round - 6 Rounds

https://www.amazon.com/dp/B004JJC2N6..._MlUiCbYZ208FJ


Since purchase I’ve learned the primer pocket is not filled in, so if you want them as a cushion for Dry Practice, they might not be the best choice. They work for me for learning to manipulate my LCR (I’m pretty new to revolvers and the LCR is my first one).

[RJ]

Does the absence of the lock allow you to replace the hammer spring without full dissasembly?

@Enel might know, he had/has a 9mm LCR I believe.


Sent from my iPhone using Tapatalk

[Doc_Glock]

@Enel might know, he had/has a 9mm LCR I believe.


Sent from my iPhone using Tapatalk

I do not know.

[jandbj]

https://www.gunsprings.com/RUGER/LCR...3/mID52/dID458

I find this most interesting for the possibility/probability that someone @HeadHunter will now swap a 10lb spring into the rimfire for a test drive.

[Gun Mutt]

Because they make a Glock look like Gal Gadot by way of comparison? Nothing against the poly Rugers function-wise, but hoo boy; fugly stick.

I don't totally disagree, but then again, I look at the right LCR, with the right grips, at just the right angle, and I get a little Deckard OG Blade Runner vibe off of them.

Anyway, my point was more about what a great resource that j-frame picture thread is...holsters, grips, finishes, sights, loading devices, it's all been covered in there. So c'mon, ugly it up a little in here.

What's the scoop on Hogue boot grips? Am I reading that they have different inserts available?


Are these no groove Hogue's the same length as the OEM grips?


Is anyone running the Hogue G10's?


And when is @VZ Grips going to offer something for the LCR? Did I miss it?

[Bigghoss]

Are these no groove Hogue's the same length as the OEM grips?

Those are standard on the LCRx3" models. They are longer than the finger groove grips, you should be able to get your whole hand on them.

[Gun Mutt]

Thanks, that's what my eyes were telling me, but I couldn't find anything specific on Hogue's site.

[MK11]

The Hogue boot grips reduce the profile of the LCR considerably and make it close to the same size as a stock 442/642. The sides seem like a slick synthetic that doesn’t bind up in your pocket or snag on your clothes while the rear retains some cushion, although that is more theoretical than practical. Shooting with the boot grips can be brutal.

[mmc45414]

I have several J-frames and an SP-101 and I would still like to have one set up like this to try.