I've got a bit of this stuff and a Dillon 550. Should I just find a home for it and buy Winchester brass or should I buy a swaging solution?
Swaging options are (feel free to add your own suggestions):
Swage it
Get rid of it, buy Winchester or X brand of brass
I've got a bit of this stuff and a Dillon 550. Should I just find a home for it and buy Winchester brass or should I buy a swaging solution?
Swaging options are (feel free to add your own suggestions):
Last edited by LittleLebowski; 08-04-2016 at 02:14 PM.
#RESIST
I never buy 5.56 brass. It's so easy to pick up. Until I got a 1050, I used the Dillon tool. If you can use someone's 1050, even just to deprime and swage, it will be a big timesaver. (The 1050 has built in swage)
Last edited by Clusterfrack; 08-04-2016 at 02:19 PM.
“There is no growth in the comfort zone.”--Jocko Willink
"You can never have too many knives." --Joe Ambercrombie
I just use one of these, but I'm only dealing with the odd crimped 9mm that happens to have gotten picked up with the rest of what I scrounged. Probably not a reasonable method if you've got a whole bucket of crimped brass.
Last edited by olstyn; 08-04-2016 at 02:21 PM. Reason: fixed typo
Ive used a simple RCBS deburring tool for crimped primers, but I wasnt doing thousands at a time. Works fine, if a little slow. Using shallow baskets to hold the brass helps some, less fiddling around reaching into containers. Shaking them sideways a little turns most of the shells mouth up. Seems like about 3-5 seconds per piece time wise when set up comfortably.
Last edited by Malamute; 08-04-2016 at 02:41 PM.
I would go with the Dillon because that is on my wish list. I have a buddy uses it and I was able to borrow it for a little while and liked it. Will buy it in the near future. Too many things need to be bought first and I have the lee tool. Not the best but works.
I've been happy with this so far.
https://www.amazon.com/gp/aw/d/B00HS...t+arsenal+case
Sent from my SAMSUNG-SM-N900A using Tapatalk
AKA: SkyLine1
+1 on the Dillon.
Easy to use.
Shumba
Thank you for starting this thread as it is also pertinent to my reloading goals, esp with regards to military crimped 7.62mm NATO ammo.
This one. It doesn't clean the bottom of the primer pocket though, just reams the crimp, and works on the case mouth inside and out after trimming, or to make bullet seating easier. I deburr the inside of the case necks on everything rifle.
http://www.midwayusa.com/product/465...-to-60-caliber
I just give them about 3 twists back and forth and the primer pocket is done as far as removing crimp.