Post your reloading setups!

[JAD]

But this is my favorite reloading tool.
http://smile.amazon.com/gp/aw/d/B000...1DL&ref=plSrch

[GuanoLoco]

Not to change the subject, but you can reload and shoot in China?

[GuanoLoco]

My shop, panorama view. Cabinet/laundry tub/wet vac on rear wall, Dillon 1050/Mr. Bullet Feeder/Mark 7 Autodrive on left wall. Back wall is custom super heavy duty storage, 9' wide. Single stage Lee press and Dillon 550 on right wall. A full set of kitchen cabinetry left over from a remodel is used for storage and holding up the "U" shaped bench arrangement. Bench top is 2 layers of 3/4" plywood.

[GuanoLoco]

Single Stage Lee Classic Cast back right wall.

[SLG]

For weighing charges, I prefer the RCBS Chargemaster. I did all of my precision rifle stuff on there for years, and quite a bit of 44 mag as well. It is slow, but tough to beat. At one point I had two of them running at the same time, but I've moved away from weighing every charge.

[GuanoLoco]

Dillon 550 Right Front Wall:



Toolheads for 1050 and 550. I can run 9 & 223 on the 1050/MBF/Mark 7 for volume, then lower volume on the 550: , 40S&W, 30 Carbine, 300 AAC Blackout, 30-30, 308 and 380. Note Dillon RT1200 size/trim on the back right for rifle calibers on the 1050 or 550.

[JAD]

Not to change the subject, but you can reload and shoot in China?

Well, yes, if you know the right people, but I'm back and hadn't updated my profile. Thanks for the reminder!

[GuanoLoco]

Thumler-B Tumbler, Bras Sorter, 8 level 400 watt dehydrator.



Harbor Freight 1 1/4 cu ft cement mixer for larger batches (30 lbs is all I can dry at the moment).

[SLG]

How much brass/water/media does that cement mixer handle?

[Rich@CCC]

I gave up on finding a digital scale for under $200.00 that was reliable and repeatable. I use an Ohaus 10-10 for my precision rifle cartridges. I throw .4-.5 grains light and trickle up on the balance. The Ohaus is sensitive enough to see the difference from one particle of powder.