Output / Runtime -- White Light
High 300 lumens / 1.25 hours*
Med 60 lumens / 4 hours
Low 5 lumens / 45 hours
Length
2 .5 inches
Bezel Diameter
0 .58 inches
Weight
1 .2 ounces
Weight w/Batteries
2 .0 ounces
* runtime per ANSI standard using included rechargeable battery
I like it.
Soldier Systems had a good review, once Amazon gets them back in stock I'm ordering a few, especially for the wife.
Damn you PF.com, there goes another $140 in my Amazon cart.
"For a moment he felt good about this. A moment or two later he felt bad about feeling good about it. Then he felt good about feeling bad about feeling good about it and, satisfied, drove on into the night."
-- Hitchhiker's Guide to the Galaxy --
You're welcome
Originally Posted by JodyH
Last edited by UNK; 12-17-2015 at 02:04 PM.
ok - that MIGHT just take the place of my Fenix PD1 as an "all the time" utility light. Which means I'll have to start humping the Fury as a "primary" light - yikes...Output / Runtime -- White Light
High 300 lumens / 1.25 hours*
Med 60 lumens / 4 hours
Low 5 lumens / 45 hours
Length
2 .5 inches
Bezel Diameter
0 .58 inches
Weight
1 .2 ounces
Weight w/Batteries
2 .0 ounces
* runtime per ANSI standard using included rechargeable battery
Man,
I'd been thinking about a Titan plus for a chain light, but this things seems to fit my needs better.
Thread on CPF.
http://www.candlepowerforums.com/vb/...in-Light/page9
Received a few days ago, reprogrammed it to go to high output on first press.
So far, very impressed!
Here is the procedure to change the order of the modes:
1. Plug the light into a power source
2. The LED should come on briefly and then shuts off before it start blinking
3. Press the power button 3 times (on, then off, then on again) and leave it on for at least 5 seconds
4. Turn it off and then unplug it.
Added to my Amazon wish list. Thank you.
--Jason--
Reply With Quote