I'm been thinking about giving my G17 RTF2 the same NP3 treatment. How do you like it?
I think the areas that would really benefit are the firing pin block, the contact between it and the trigger bar, between the connector and trigger bar, and between the striker and trigger bar. Any other pluses?
Last edited by Exiledviking; 01-19-2018 at 01:26 AM.
@Exiledviking
I did it because of durability issues with the original plating. It did slick up the trigger pull a bit.
Robar won't do the striker for some reason.
So this happened today!
Gen 4 19
- ZEV Pro Trigger (non adjustable)
- ZEV Trigger Spring
- ZEV Connector
- ZEV Extended Mag Release
- Dawson Precision Adjustable Sights
I really like wha the ZEV parts did with the trigger, it reminds me of a Geissele S3G.
In a few weeks I’m going to send it off to Mod 1 firearms to have them do:
- Full Slide Bevel
- Front Cocking Serations
- Double Undercut Trigger Guard
- Stipple
- Cerakote Slide (Gray)
I’ll possibly have them go ahead and mill the slide for an RMR as well and I may install a KKM threaded barrel as I plan to add a can down the road. However if it weren’t for the suppressor I’d leave it alone as the factory barrel seems to shoot just fine.....
10 rounds of 135gr Hornady Critical Duty Practice @25 yds.
Sent from my iPhone using Tapatalk
Last edited by Mr. Goodtimes; 01-24-2018 at 08:00 PM.