HiTS titanium knife question

[Crusader8207]

I have and love the HiTS titanium knife that Joe Watson made. I am trying to find a way to carry it. I tried to get a Spyderco G Clip to attach but the spacing is off. I understand the hole spacing is closer to the large Tec-Lock. I'd like something a little more low profile. I wan to carry it at 3 or 4 o'clock. Suggestions?

[Crusader8207]

Thanks, I just found out that Bladetech makes a clip that will work with it. I think I will give that a try.

Mike

[Wondering Beard]

Have you tried in between the pants and belt (or straightforward IWB) with the belt loop that normally comes with it?

[Crusader8207]

This is what I ordered: http://shop.blade-tech.com/bladetech-clip-p-143.html

[Crusader8207]

I have tried that but I find that it rotates forward a little too much for me to get an effective grip on it each time.

Have you tried in between the pants and belt (or straightforward IWB) with the belt loop that normally comes with it?

[Wondering Beard]

I have tried that but I find that it rotates forward a little too much for me to get an effective grip on it each time.

Makes sense.

That Blade Tech part looks like it could do a good job.

P.S. I wonder if Tracker Dan would make sheaths For more Watson models.

[Crusader8207]

Makes sense.

That Blade Tech part looks like it could do a good job.

P.S. I wonder if Tracker Dan would make sheaths For more Watson models.

The Tracker Dan sheath would be a good solution too. I will report once I get the clips. Should have them early next week, I hope.

[Dagga Boy]

Tracker Dan and Joe are very close...they are way ahead if you.

[Wondering Beard]

Ooh!

Do you know if the sheath might be sold separately? I have HiTS and a Small Bowie (and Ti) that would like a Tracker Dan sheath.