What parts would you recommend for a spare parts kit for a Glock 17
So far my thoughts are:
1. Trigger Spring
2. Recoil Spring
3. Extractor
4. Extra set of pins
I am sure some other stuff should be ordered but I am not really sure what. Any help is appreciated.
I keep everything but a slide/barrel/receiver. All springs would be a good start and all most will ever need.
Trigger bar assemblyOriginally Posted by foxj66
Connector
Slide lock spring
Firing pin safety assembly
Extractor assembly (suggest the Apex part over Glock)
Striker spring
Spring cup set
Regional Government Sales Manager for Aimpoint, Inc. USA
Co-owner Hardwired Tactical Shooting (HiTS)
Same here. I learned the hard way not to neglect maintenance when my G19 slide flew off of the frame during an Aim Fast Hit Fast Class. I'll never live that down.
Front sight screw.
If you are losing front sight screws you may as well have the whole front sight.
I have a few of them in my bin.
Little black Glock armorer tool.
Likes pretty much everything in every caliber.
This is better because it has the front sight hex driver, and it's all metal:
http://www.brownells.com/gunsmith-to...-prod9776.aspx
Thanks so far everyone. I should have mentioned I already keep a 3/32 punch and a front sight driver in my bag.
So far I was able to pick up an extra
Slide lock spring
Trigger and locking block pin
Recoil spring (already had a spare on hand)
For the ejector pin I will keep the short one on hand as I use the back strap and can always go without if needed
Trigger bar
Slide release
What about the cover plates are the magazine catch any need for them before I put an order in? Are the locking block and slide lock needed?
Last edited by foxj66; 02-05-2015 at 06:10 PM.
If you break a slide lock spring, you might lose the slide lock too. I would have both on hand.
A slide release isn't a bad idea.
I don't carry mag parts because I have a ton of mags.
Reply With Quote