Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: 00 Flitecontrol - bad pattern

  1. #21
    master of none blues's Avatar
    Join Date
    Aug 2016
    Location
    blue ridge mtns
    Quote Originally Posted by Tabasco View Post
    I bought a case of the old Federal H132 00 in 1999. Gone through 100 rounds or so last month, and it seems to work just fine. YMMV
    I've also fired off 00 and slugs dating from around the same period during the past year. The very few that had obvious corrosion on the brass were not tested. All the others fired without exception.
    “Tactics without strategy is the noise before defeat.” - Sun Tzu // "Everybody has a plan until they get punched in the mouth." - Mike Tyson

  2. #22
    Site Supporter
    Join Date
    May 2016
    Location
    Dallas
    Quote Originally Posted by David S. View Post
    You might try picking up a box of brand new ammo before you go too far down the rabbit hole. I don't remember the details, but seem to recall Dagga Boy say that shotgun shells have a short shelf life. Like a year or two.
    If left loaded long enough, hulls can compress and start to mushroom or flare and cause feeding problems. It's most evident in a magazine fed shotgun like a Saiga, and in a tube even cheap stuff will take years to deform. Stiff Flitecontrol/Versatite wads that run the length of the hull make it a non issue on relevant Federal and Hornandy buckshot in a tube. Since "sealed" shotgun hulls can only be counted on to resist incidental contact with water, it doesn't hurt to change them out on an annual basis.

    Stored properly they should have a decades long shelf life, but I'd keep fresh stuff in the shotgun and save the ammo testing for the range.
    Last edited by txdpd; 07-18-2017 at 01:14 PM.
    <---Not very articulate.

User Tag List

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

TLG 1970–2016 RIPRampageForTheCure.org