Beretta 92 Magazines

[GyroF-16]

As a follow up, I ordered these on 10/2 using that link and the seller never communicated or did anything so I canceled it as of today. In any event I saw today in the 1911 thread where someone said their blue mags got chewed and left plastic debris inside the weapon, to its detriment. I guess I will go with dummy rounds in old magazines.

Thanks for the update and info.

I was eying these for training, but will remove them from my wish list.

[Hambo]

I just got 2 Mec-Gar 18 rounders and put 50 rounds of Federal 124 grain AE through each without issue. I’ll put some 147 grain HST through them before declaring them good to go.

They work just fine with 147gr HST, both regular and +P.

[JSGlock34]

https://czcustom.com/spring-mag-mecgar-follower.html

Just chuck the follower. You're welcome.

Are the springs themselves actually identical, or not exact but close enough to be functional?

[Sal Picante]

Are the springs themselves actually identical, or not exact but close enough to be functional?

I don't have a way to check the spring constants/rates/etc... That said, it drove me nuts to order aftermarket springs, which wouldn't fit the MecGar floor plate, required clipping, didn't hold 18 rds in the 18 rd tube (because they compress into themselves, unlike the wolf units).

These have worked for me in the 18rd and 22 (18 rd +4 extension) magazines I've had.

[JSGlock34]

Thanks, I'll order some.

On the subject of magazine springs, what's the preferred option for OEM 15 round magazines? Beretta springs or the Wolff +10%?

[spence]

Thanks, I'll order some.

On the subject of magazine springs, what's the preferred option for OEM 15 round magazines? Beretta springs or the Wolff +10%?

I'm no pro, but for whatever it's worth I've got a bunch of USGI type mags that are loaded with the Wolf 10% extra power springs. If I was replacing springs in factory mags, I'd use the same springs, too.

[Hambo]

I've been using Wolff +10's for years.

[Sal Picante]

Thanks, I'll order some.

On the subject of magazine springs, what's the preferred option for OEM 15 round magazines? Beretta springs or the Wolff +10%?

The Wolff +10's are great there...

[JSGlock34]

http://instagram.com/p/B5EaOGNA-Pt/

[Stony Lane]

MecGar sent me this information on the 18-round Beretta 92 magazine parts:

Please call the number below to place an order.

PRICES:

Springs:

Single: $6.95

Three Pack: $16.95

Ten Pack: $45.95


Locking Plates: $4.95

Floorplates: $ 6.95

Followers: $4.95

Shipping: Flat $3.95


Mec-Gar USA, Inc.
905 Middle Street
Middletown, CT 06457

Tel: 860-635-1525

Fax: 860-635-1712
Web: www.mec-gar.com