I was told I need the SRS-1, http://www.cajungunworks.com/short_r...tem_-_srs.html
I'm not that worried about the hammer, what sights are available of it?My sp-01 I got new for a trade,my last cz was a turd,I hope I have better luck with this one.
I was told I need the SRS-1, http://www.cajungunworks.com/short_r...tem_-_srs.html
I'm not that worried about the hammer, what sights are available of it?My sp-01 I got new for a trade,my last cz was a turd,I hope I have better luck with this one.
SRS 1 with their disconnector is a nice combo. Polishing is a must, it's not that hard. Get some extra firing pin block lifter springs, they have a tendency to fly away, never to be seen again. There's a lot you can do with these things
This thread has my interest hardcore, now.
Are there any good match barrels for CZ guns?
Also, I'll repost my old question:
If you can mill it out for a Heinie sight, can you do that for a 10-8 sight?
Originally Posted by montanadave
Attachment 2103
Concentrate on targets.
For those that want a preview of the 2014 CZ custom shop guns here is a video. Enjoy.
After shooting my Mink Shadow today, late in the session I pulled out my CZ Custom P01 L. The little gun was whacking the 8 inch steel at 35 yards every shot. Whether because of accuracy or ergonomics, the P01 is one of the MOST shootable little guns I have shot. It really handles like a 9/10 capable full size Shadow.
Likes pretty much everything in every caliber.