Shot this today. I almost lost my mind pushing all the little pieces into alignment. My table is a little rickety. So, every time I breathed on it a spring or pin would roll... Photoshop would have been a lot easier.
Shot this today. I almost lost my mind pushing all the little pieces into alignment. My table is a little rickety. So, every time I breathed on it a spring or pin would roll... Photoshop would have been a lot easier.
That's not as bad as I thought it would be-parts wise.
Nobody is impressed by what you can't do. -THJ
Very nice photo.
You can get much more of what you want with a kind word and a gun, than with a kind word alone.
I'm not very "handy" and found the detail stripping of a 1911 isn't that big of a deal. I took LAV's 1911 Operator's course last year and wanted to make sure I knew what I was in for so I had a buddy walk through it with me once before class. I then did it once more on my own before class. By the time class rolled around I was comfortable with it.Originally Posted by BOM
The first time is the hardest just because of the intimidation factor. Now, I haven't done it in almost a year .... since right after the August class. I will likely have to sit and stare at it a while the next time I do it.
Good job on the photography.
I find the 1911 to be pretty simple to take down and put back together. Fitting of certain parts that can be intimidating but they are a relatively simple design.
Last edited by SecondsCount; 06-08-2011 at 12:32 PM. Reason: grammar
-Seconds Count. Misses Don't-
Great picture bro!
I recently acquired an Armscor 1911 in a trade, and I figured it would be a POS, being Phillipine made and all. It had a full length guide rod, which I ditched and replaced with Milspec parts. It actually works really well! No issues at all. I'm going to get the sights regulated with WWB, and put it to the 2000 round challenge, just to see if it'll do it.
My point in saying all of that was, you are completely right...the intimidation factor is the worst! I'm not to the point of detail stripping yet, but I'll be there soon!
Yeah they aren't too bad to take apart and re-assemble, if you do it right.
I found out there is sort of a specific order they need to be put back together though. I think I got too excited and installed the mainspring housing before the safety was in place and I found out the sear didn't work. I forgot what I did to fix the problem but certain parts got bound up and it took me about 10 minutes of fumbling, but I got it working.
I can't really speak on how bad the several different types of firing pin block safeties are to re-assemble, but it seems most of the people that have taken theirs apart don't need to go to a gunsmith to put them back together.
They really are stone-axe simple. Most modern DA/SA autos are a LOT more complicated to detail strip.
I took a rather close look at a field stripped 1076 this morning and was SHOCKED at the multitudes of plungers and levers and tiny springs and is that the ejector that pops up from the frame and oh my god....
I'd rather detail strip a badger.
Nobody is impressed by what you can't do. -THJ
Well done!
1911's are actually pretty darn simple, assuming the parts were built and fitted correctly in the first place...
Reply With Quote