Beretta 1301 Tactical

[nycnoob]

Who can tell me what this is?

Its a modern version of this factory:

[SpyderMan2k4]

Cut and paste, mostly. The "cage" that runs through the center of each shroud constrains everything so that in the eyes of the commercial 3D printer it is one part and not 72 parts. This is important because they charge a significant "handling fee" per part. I'm gaming the system.

Sneaky

[MichaelD]

I should add that none of those parts are physically connected to each other. I can just clip the cage and the parts will fall out and be identical to ones produced one at a time.

Double sneaky!

[JM Campbell]

Double sneaky!

Engineers....gotta watch your six around them dudes.

Sent from my SAMSUNG-SM-N900A using Tapatalk

[LangdonTactical]

Does it tend to lose zero with heavier loads?

Not so far, is there something I should know?

[SpyderMan2k4]

Not so far, is there something I should know?

Same here. I've rolled with an H1 on an 870 and now the 1301, no noticeable change at 75 yards with slugs

[SpyderMan2k4]

I put 50 rounds of birdshot and another 25 of 00 with the shroud on and everything worked as intended. Not surprising, but I guess it's with noting. Good stuff.

[Crusader8207]

Received the shrouds. I really love the flush one. I will run them all this weekend and will report.

[SpyderMan2k4]

It should be noted that your shroud and everyone else's shroud, are not the same shrouds. Not that it should matter, but still.

Just affirming the concept is sound and works as intended

[BamBam70]

Got my packet today as well. I'll be sure to put up test comments soon. Thank you!