Being a fan of anything double action only and oddball designs, I bought a 590DA when they first came out.
Totally worked as far as shooting went.
Then it quit shooting.
Enough with the clever punctuation. The DA pull was controllable and I liked everything about this design. After a pretty low round count of low recoil buckshot (less than a 200, I still don't keep a strict logbook, sorry) the hammer would occasionally not release at the end of the trigger stroke. I lost interest quickly at that point. My suspicion is I wasn't the only shooter with this problem and that's why it disappeared so quickly. Since that time I've migrated to semi-auto designs that will work with the low recoil stuff. Might I recommend a Browning Auto 5 set for low or even a 1301?
My apologies to weasels.
I知 preparing to add a sling to my LTT 1301. I知 going to use a Magpul MS3 that I already have. It has QD on one end and their Paraclip on the other; it can convert to a single point as an option. I知 going to use a QD mount in one of the MLOK slots on the handguard, undecided on the rear. I知 leaning towards keeping the Paraclip on there which will require me to add something like the Magpul SGA. Does the LTT 1301 use the Remington 870 stock or the Mossberg 590?
I知 looking at putting a sling on my 1301T w/ Magpul stock and forend. The MLOK slots are already occupied with a light and pressure switch.
I see the obvious sling loop in the Magpul stock. Who痴 found a good solution for attaching the sling somewhere forward of the receiver?
I use IWC QD mount n slot cup in the Zhukov's half MLOK slot just in front of the receiver. There's also the Nordic Components barrel clamp with a QD cup or the Briley mag tube extension with sling swivel mount.
https://www.impactweaponscomponents....-detach-sling/
https://nordiccomp.com/categories/be...-barrel-clamp/
https://www.briley.com/p-52254-brile...x-stoeger.aspx
I just got a notification that nordic extensions are back in stock at various places. I haven't used ordered from any of them before, so you might want to check out their site reviews first: https://gun.deals/search/apachesolr_search/816696021447
So I finally installed the Aridus Zhukov on my 1301. Great feel and seems pretty solid. But I notice one thing that I hadn't before. When racking the bolt, I notice the carrier assembly 'rods'(For lack of a more knowledgeable term) rubs against the Aridus adapter-tabs on either side when pulled back. They don't seem to impede or rub hard against it, but you can hear them slide slightly against it. I haven't had to shoot it with the new forfend installed, but does anyone know if this will hamper the operation of assembly? Is this normal?