Figure I’d post some shooter’s view pics of my MRO/Rusty Nuts setup…
This is what it looks like when the dot is centered in the housing:
And if I tuck my cheek down a bit to use the irons:
In the pic, the sight picture looks a little cluttered with irons, but when shooting with the dot, I’m TARGET focused and everything just washes out. I’ve contemplated machining off the top portion of the rear ghost ring, but it won’t be necessary… but I might do it just to try it out.
Couple of tips on O-rings
1. While cleaning the 1301 I blew out the gas cylinder with my compressor and blew the gas cylinder O-ring right out. Luckily I didn't loose it and it was undamaged!
2. The Firing pin O-ring and the firing pin retaining pin O-ring are interchangeable. They both have the same part# C5A354
3. Probably a good idea to have some spares on hand!
Are you loyal to the constitution or the “institution”?
Got out to the range this morning to sight in my 1301. Really easy to sight in w the Truball slugs at 25 yards.
After sighting in the slugs I shot some more 8 pellet FC loads. Either this lot has some issues or my 1301 just doesn’t like them. Patterns were shitty at 25. Although some of the patterns at 15 were awesome, I had one the was very inconsistent. Plus I had 2 FTEs.
As you can see, 4/5 were great, but the 4th shot (the one at the head) was very inconsistent with the other 4.
After patterning the 00, I ran a box of 7 1/2 3dr field loads through it. Ghost loaded to 9. Ran like a scalded dog. So far the only issues I’ve had with this have been the 8 pellet FC.
I’m gonna pattern some of the 8 pellet through my Tac-14 when I get the chance to see how they do.
Formerly known as xpd54.
The opinions expressed in this post are my own and do not reflect the opinions or policies of my employer.
www.gunsnobbery.wordpress.com
New Guy...First Post
Just picked up a 1301 TT18C version. What did Beretta do to make this version now 922 compliant, all parts made State side ?
Here's a good view of my 3/4 U-notch aperture
Are you loyal to the constitution or the “institution”?
Here’s my poor photo-chop of how I was thinking of modifying the factory ghost ring. I wanted to cut the top off and make it more like traditional pistol sights… opinions???
Any idea when the Gen 2 came about?
Are you loyal to the constitution or the “institution”?
it appears the Gen 2's came out around September 2018 and the Gen 3's came out around September 2021 with factory 7 round capacity magazine tubes and a new M-LOK compatible barrel clamp with dual integral QD Sling swivels.
Are you loyal to the constitution or the “institution”?
Got my “last” piece in the mail this week.
5 day transit from UK. Great service!
https://www.customguns.co.uk/product...release-handle
Adding some photos of my boomstick “build”.
I had the stock and handguard stippled.
^Nice setup. You must be lefty
Are you loyal to the constitution or the “institution”?
Reply With Quote
