Search:

Type: Posts; User: Crazy Dane

Page 1 of 12 1 2 3 4

Search: Search took 0.02 seconds; generated 20 minute(s) ago.

  1. Well, I've slugged my barrel. There is just...

    Well, I've slugged my barrel. There is just something creepy about driving a hunk of metal down a barrel. Anyway, it measured out to .431 and I have an email in to MBW to see what they recommend.
  2. I have used a fair bit of cast bullets in this...

    I have used a fair bit of cast bullets in this gun including some big SWCs, and there is no suppressor. The wide flat points that I'm looking for seem to gas checked from MBW and nowhere else. I'm...
  3. Because a wide flat nose has been recommended, I...

    Because a wide flat nose has been recommended, I have found these 3 that I want to try, 44 Mag, LBT, 280gr, WFN-GC - Montana Bullet Works, 44 Mag, LBT, 260gr, WFN-GC - Montana Bullet Works, 44 Mag,...
  4. I have used a lot from Missouri Bullet Company...

    I have used a lot from Missouri Bullet Company and snscasting. No complaints on either.
  5. It was at least an hour after my incident when I...

    It was at least an hour after my incident when I puked into an Idaho Falls Pd trash can. It was another 30 minutes until I was able to regain composure and continue with my statement.
  6. Replies
    17
    Views
    1,386

    A bullet gets pulled by forces in recoil so a...

    A bullet gets pulled by forces in recoil so a pulled round will not be in the forcing cone. A pulled round does have the potential to be a squib and that causes a bit more problems.
  7. Replies
    17
    Views
    1,386

    I had one of my reloads pull in my LCR. Round #5...

    I had one of my reloads pull in my LCR. Round #5 stopped cylinder rotation. No drama, turned the gun vertical, hit the ejection rod and very slight pressure to dislodge the pulled bullet. Dropped in...
  8. Replies
    31
    Views
    1,576

    Poll: I do not have a .357 rifle yet, so I don't have...

    I do not have a .357 rifle yet, so I don't have experience there. However, I do have experience with a .44 mag rifle and have been doing a lot of research ISO a better hunting bullet for a .44 mag...
  9. Replies
    31
    Views
    1,576

    Poll: I have had coyotes and black bear in my yard and...

    I have had coyotes and black bear in my yard and I frequent the woods where feral hogs roam. The likely hood of having to deal with a bear is low but not zero. Coyotes are invasive to WNC and need to...
  10. Replies
    31
    Views
    1,576

    Poll: Since most of my threats run on 4 legs, 158 SJSP...

    Since most of my threats run on 4 legs, 158 SJSP or 170 SWC loaded in .38 cases to .38-44 velocities. A 2 legged varmint isn't gonna notice that I'm not using a "defensive" round.
  11. Replies
    23
    Views
    1,807

    If I have read this right, you shot 359 rounds of...

    If I have read this right, you shot 359 rounds of magnum ammo plus 38 of .38 in one range session?! WoW, you go girl...:cool:

    To answer what has already been answered, yes, its carbon build up....
  12. Replies
    80
    Views
    6,898

    Poll: This is where I screwed up. I put the pin across...

    This is where I screwed up. I put the pin across a hole in my armorer's block and hit it with a big punch making a not so gradual bend. I wish I had the skills to spline, that seems to be a more...
  13. Replies
    80
    Views
    6,898

    Poll: All 3 of my GPs did this. The correct way is to...

    All 3 of my GPs did this. The correct way is to source oversized pins, I didn't have any patience for that so I used 2 methods found on the interweb.

    1 - take the pin out and slightly flatten one...
  14. I did some work on Hornady's ballistic calculator...

    I did some work on Hornady's ballistic calculator (checked results against 2 others) using their impact velocity chart and came up with some good theoretical data.


    The 200g XTP has a max impact...
  15. I tried the 270g Deep curl, out of a 5 shot group...

    I tried the 270g Deep curl, out of a 5 shot group with 3 different charge weights and 2 different powders, total of 6 groups, I could 3 or 4 in 1 1/2 then the fliers would leave you thinking Ray...
  16. I've seen those images and they do cause concern....

    I've seen those images and they do cause concern.




    I like duck.

    I've used hard cast in the past and it is not lost on me. I've pulled fired bullets out of a red oak stump that I use as a...
  17. ISO a better hunting bullet for a .44 mag rifle

    I took both of my north Georga bucks this year using my 1894 .44 mag. The load is a 200 grain XTP on 28 grains of W296. Book velocity shows ~2100fps out of a 20-inch barrel. (now that I have my...
  18. Replies
    19
    Views
    1,437

    I have used a few hundred of 5 1/2s and ran them...

    I have used a few hundred of 5 1/2s and ran them through my Rugers and Pythons with no issue. The Rugers, GP100 and SP101 have reduced power springs.
    \
    As for the primers this is from their...
  19. Replies
    81
    Views
    3,577

    The best way to get 12 shots of .357 is to have 2...

    The best way to get 12 shots of .357 is to have 2 6 shooters, one for each hand.
  20. Poll: I have watched this guy too, his shop is about an...

    I have watched this guy too, his shop is about an hour from me never been there tho. He seems to be genuine and honest, but his testing leaves me wondering. Going out and running a tank of whatever...
  21. Poll: I have a Husky 572 and I have run a 32" bar on...

    I have a Husky 572 and I have run a 32" bar on it, did ok. It now has a 28" Husky branded Sugi lightweight bar on it and Oregon EXL chain now and will take a full bar of red oak without hesitation. ...
  22. Replies
    41
    Views
    1,850

    Boat - Bust Out Another Thousand; A hole in the...

    Boat - Bust Out Another Thousand; A hole in the water in which money is thrown.

    My fishin boat. I could buy a lot more guns if i dint have this but my time on the water is priceless.

    ...
  23. Replies
    18
    Views
    1,417

    So you're sayin there is a chance? I have been...

    So you're sayin there is a chance?

    I have been trying to score one of the 4 5/8s model since they hit the market. Lost a couple of gunbroker auctions because the price got silly high. I would...
  24. Replies
    90
    Views
    7,390

    Just got mine in, paired and charging. I've read...

    Just got mine in, paired and charging. I've read the instructions and got a question. I do/did my pistol testing standing, how high over this thig can you be? If I set it on a 5 gallon bucket will...
  25. Replies
    32
    Views
    1,879

    Poll: I voted for the OP is crazy. I can check every...

    I voted for the OP is crazy.

    I can check every box, sometimes multiple in a day because it all depends, this is where the revolver shines for me. From my LCR 9 to my M29 the manual of arms is the...
Results 1 to 25 of 295
Page 1 of 12 1 2 3 4