This sounds like a good suggestion. I'll try it after I finish wrapping Christmas gifts (which could be a while). Thanks.
Type: Posts; User: Cornerpocket
This sounds like a good suggestion. I'll try it after I finish wrapping Christmas gifts (which could be a while). Thanks.
It binds some with an empty case in it. I think it may be a burr around the firing pin hole. The guy below may have figured it out. Thanks for the input.
I just went downstairs and checked. I think this could be the problem as there is a burr around the pin hole. It's slight but that is definitely where it is sticking. I put an empty case into the...
Thanks for the suggestion. I'll give it a try tomorrow.
38 spcl. Winchester White Box, 125 or 130 grain (can't recall which) and some Federal. Nothing exotic. Just factory hardball range ammo. No 357 mag.
Last year I got a Uberti Cattleman II and have, up to now, fired less than a hundred rounds through it. Although it was fine on my first range trip (other than screws loosening which I think I got...
Thanks for the input. Sounds like trying to get some higher quality screws may be the way to go. I really appreciate the information.
I asked this in another forum and didn't get much response so I thought I'd try here. I recently purchased a Uberti Cattleman in .357 magnum. I've had it out to the range four times and put maybe 100...
I recently got a Smith and Wesson 640 and, like a lot of others, am considering changing out the sight. I read a discussion on another website, snubtraining.com, about replacing the factory sight...
Whenever I have read about proper draw technique there is a great deal of discussion about actually drawing the gun (as in raising it from the holster), rotation, punch out, etc. There is very little...
Thanks for all the suggestions. A little more dry firing and mag changes in the basement tonight and I'll see how it goes tomorrow. Your help and suggestions are appreciated.
I posted this same request in another forum earlier today and got some nice responses. I figured it couldn't hurt to toss the same issue out in another place. I expect to be shooting my first IDPA...
Thanks for the additional input in these latest replies. I will check them out.
Thanks for the input. I know there are some websites for guys in the local area and had seen them. I was hoping someone may have had personal contact with someone they found particularly good that...
Hello all,
I'm a new member (this is my first post) who has been reading the forum for several months now. I migrated here from a couple of other forums. The quality of the posts and discussions...