https://www.gunpartscorp.com/ aka Numrich
Type: Posts; User: xcop
https://www.gunpartscorp.com/ aka Numrich
Here is my 1978 Cobra. Bobbed by a Colt repair center and carried as a backup and off duty for a few years. Grips are Altamont and the grip adapter is from Tyler. I have a set of the grips with the...
As soon as the first one of these "non police" get hit or shot at or chased by someone with a knife it will end.
I am always impressed when a supposed LE test is unable to spell marshal and sheriff correctly.
" Marshalls, two Texas State departments, 4 police and Sherriff departments"
The test data might be fine but there is no way in hell a coroner does a little over 8 autopsies in a day. Take the narratives with a huge grain of salt. That means the opinions that go with them. Re...
I tested this round as well as the 110+p+ Winchester thru my 2.25in sp101.
357 avg velocity was 1219 for 5 shots. It penetrated 9.5in thru a layer of 14oz denim, a sweatshirt and a thick T shirt....
Cant say .....the dept armorer killed the range chrono on the first shot of some 9mm we were testing
I fired several different 38 and a couple of 357 rounds from my 2.25in sp101 into a Clear Ballistics Block at 10 feet. Clothing barrier was a layer of 14oz denim, a sweatshirt and then a thick T...
Using my 2.5in 686+ the Gold Dot 135 mag averaged 1104 for 5 shots. Very mild and shot to the factory set sights at 15 yards. The only 4in I have is a 581 and for that I use Remington 158jhp
I know sticking with the Big 3 is best but there is a hard cast 38 wadcutter at a claimed 740 from a 2in loaded by DoubleTap. I received 60 rounds but have not fired any yet. The bullet is seated...
I had the same thing happen to a 649 I was carrying. I sent it back to Smith and it came back within a few weeks. They also had polished the frame and beveled the back of the cylinder free of charge....
https://generalcartridge.wordpress.com/2017/11/20/federal-38-spl-p-130gr-hst-in-clear-ballistics-gel/
[QUOTE=Doug MacRay;641867]Here's another 10% OG vs 10% CG comparison video from BrassFetcher that shows significantly deeper penetration in cleargel. So fairly significant differences between the...
People seems to agree Shooting the Bull410 did a good job on ammo testing. Here he compares 10%gel and clear ballistics with a few different rounds. Worth a look
...
Clear gel w/o heavy clothing
https://www.youtube.com/watch?v=YgGjNQ_hhIQ
Buffalo Bore also makes a nice 200gr hard cast wadcutter listed at 1000fps.
Tamara if that testing with the clear ballistics gel is yours do you have any numbers?
This is a screengrab from Brassfetcher showing 9mm 124gr xtp into 10%,20% and wet pack.17788
Just found this...chrono,wetpack and targets shown
https://www.thefiringpen.com/single-post/2017/05/22/Federal-Personal-Defense-38-Special-P-130-gr-HST-Micro
Hope I am not breaking a rule here but the following came from the Smith and Wesson forum in their ammo section. Again not my testing.
2" S&W M337:
High 800 fps
Low 799 fps
Yes, a total for...
I shoot all my handguns straight on. Sorry to see what these newer Smiths have ended up doing. That is a very large POA/POI difference. Good luck!
D&L makes rear sights you can add...
LTDave.......assuming you use a 6 oclock hold what hits closest to POA in your 640?
Photo but have not seen specs. The case on the left is a fully loaded round. They seat it like a wadcutter
13272
Los Angeles sheriff issues 147HST. Not sure if they switched the 45acp yet
I tried a Smith 940 and didnt like it. Moon clips are a PITA to load and unload. The gun also would fail to eject many different brands of ammo without having to pound them out. Big issue is you cant...