Does any company make a quality scope mount in a 1.7-1.8" height?

I have an IWI X95 Tavor and I found most optics meant for an AR sit around 1.5" tall which is just a hair too low for it. Right now I have an 4X ACOG with a kram spacer that puts it right around 1.7" and that is perfect. However I am thinking about getting a LPVO 1-6x of some variety to put on it but it looks like the only options I can find for 30mm single piece scope mount all come at 1.5" for standard height or 1.9" for NVG height which is just a bit too tall for my liking.

Does any company out there make a scope mount that is closer to that 1.7"

I know I could go with a spacer but that looks ugly and adds an extra point of failure with the mount that I'm trying to avoid.

Badger Ordnance makes a 1.7" mount.

https://www.badgerordnance.com/condi...3rd-black.html

It is a fantastic mount, but pretty hard to find these days.

https://www.rockriverarms.com/index....tegory_ID=1501 is the another choice besides the Badger for cantilever, though I'm not sure I would trust that any more than a quality mount with a quality riser.

EraTac has a non-cantilevered 34mm mount at 1.65" height, which should work fine with a Tavor, though you'd need a 34mm optic at that point.

If you opt for something with a 34mm tube, the American Defense RECON-M is 1.7". (It's 1.63" for 30mm.)

Been running the Badger Condition One mounts on some of our work guns (.308/5.56) AR platforms. I really like them.

Quote:

---

Originally Posted by dontshakepandas

Badger Ordnance makes a 1.7" mount.

https://www.badgerordnance.com/condi...3rd-black.html

It is a fantastic mount, but pretty hard to find these days.

---

Hard to find because they don't make it anymore or because everything is hard to find with the pandemic?

Quote:

---

Originally Posted by mrozowjj

Hard to find because they don't make it anymore or because everything is hard to find with the pandemic?

---

The pandemic plus just extremely high demand in general. It took me a few months to find mine.

Quote:

---

Originally Posted by dontshakepandas

The pandemic plus just extremely high demand in general. It took me a few months to find mine.

---

Well that's slightly better than not making them I suppose.

Quote:

---

Originally Posted by Default.mp3

https://www.rockriverarms.com/index....tegory_ID=1501 is the another choice besides the Badger for cantilever, though I'm not sure I would trust that any more than a quality mount with a quality riser.

EraTac has a non-cantilevered 34mm mount at 1.65" height, which should work fine with a Tavor, though you'd need a 34mm optic at that point.

---

Any recommendations for a riser that isn't ugly and is quality? I might end up going that route.

Depending on your intensed use for the gun and the optic you are using, I wouldn't completely rule out a 1.93" for that setup. I'm using my 1.7 for a more precision oriented gun where I could end up spending more time shooting from prone and 1.93 could get a bit uncomfortable for longer periods of time. For more general use setups 1.93" is fantastic and you'd likely adjust to it pretty quickly if you are using an optic with a forgiving eye box like a Razor or Kahles. Maybe less so with something like a Nightforce NX8 that is a little pickier about eye placement.