If I were to have my non-mos 48 for a 507K, are standard height Ameriglo useable through the window or do I need tall sights like 10-8 48 mos sights?
Printable View
If I were to have my non-mos 48 for a 507K, are standard height Ameriglo useable through the window or do I need tall sights like 10-8 48 mos sights?
Sorry for the crappy pic. Can’t get the iPhone to focus right. Anyway you can just barely see the top of the front sight circle. The sight are agents with a .190 front. I’m looking for taller sights but haven’t been able to find a set that will work yet. IMO I think mos suppressor sights would be too to tall.
Attachment 65581
Hmmm I wonder what would work.
As stated Agents are barely visible... until you get that little line of hard to get at dust at the bottom of the window. Then they aren’t really useable at all.
If mos suppressor height is too tall, what is just right?
I still have a blockage when it comes to a Chinese optic vs Trijicon but they don’t make a g48 sized optic yet.
Not if you don’t mind grinding off the 2 rear bosses. That’s what my buddy did. Worked fine.
Attachment 65611
He’s using Ameriglo GL-506 which I personally think are too tall.
Here’s what I use on my Brownells G19 slide with an SRO. I imagine, but can’t promise, this would work on a 48 MOS with a 407k direct mounted. They’re taller than typical irons but shorter than the normal MOS sights. Ameriglo sights.
Attachment 65612
Attachment 65613
Would that be the same with a non-mos 48 (that’s what I have)? I’d be milling my 48.