Printable View
I just got a titanium cylinder for my S&W 642. When adding the cylinder to by revolver, I lubed the extractor rod with Sentry Solutions Tuf Glide lube. I then notice that the Tuf Glide has mineral spirits in it and that may not be good for titanium. Did I just hurt my new titanium cylinder or am I ok?
Paging @Aray
The big concern on S&W cylinders is the surface coating, as the Ti erodes quickly once the coating is gone. I wouldn't expect mineral spirits to hurt it, as it's just a hydrocarbon solvent. I'd avoid anything with a non-neutral pH.
S&W revolver Safety & Instruction manual. Pages 26, 28-29 addresses your concerns. Click on revolvers with the J, K, L, N frames listed, found on page 2.
https://www.smith-wesson.com/custome...owners-manuals
I hate to say it, but its just not there.Quote:
Originally Posted by JAH 3rd
https://snwcdnprod.azureedge.net/sit..._416560000.pdf
Page 30 says: Refer to the “Lubrication” section in this manual for instructions on lubricating the firearm.
While a search for the string "lubrica" turns up six matches, none of which is the section mentioned.
I looked at the link you provided. On page 26 of the pdf manual download, is where the info is about the titanium cylinder care. It is at the bottom half of page 26. It gives the do's and don'ts of how to clean the titanium cylinder. Cleaning and maintenance does start on page 30-32. Hope this helps. Firearm manuals today tend to be wordy which makes finding specific info (for me) challenging.