Good way to mount an AR scope LOWER?
Is there a good way to mount a low power variable scope at approximately 1.25" to centerline on an AR? Or even very slightly less?
Most of the one piece mounts are 1.5" or higher, and I find that to be too tall for an optimal cheek weld, personally. It is even worse for my young daughter. She only gets a marginal jawline weld. I can see the utility if you are trying to go over the top of BUIS, have a giant 50mm objective lens, or have a relatively large/thick head/face. Using traditional rings seems like it would push the optic back to the rear quite a bit?
I'm thinking about a simple, lightweight BCM ELW-F upper with nothing else mounted on it. Just a lightweight LPV optic that's mounted lower to optimise cheek weld. And a sling.
Are there any good, lightweight options for doing this?