I bet they do. I believe Shield already has done packages with Glock over in Europe for the little MOS guns. I wouldn’t be surprised if they are the next up. (I’m ignoring the oddball Noblex-Docter sight.)
Printable View
Can anyone with an MOS plate measure the distance between the mounting-to-the-gun plate holes? (Or the distance between the SCS mounting holes)
With the right distance, it would be easy to direct-mill almost any slide. I have milled for a DDP and know for a fact that they are 14 mm (0.551 inches.) If/when a red dot comes out for them, I can actually use it on previously milled slides that have 14 mm between holes (Docter, Venom, Viper, Holosun 407K/507K, Fastfire III, Shield, etc.)
I used to ponder not having lugs that are used to locate red dots on guns. I have never had a failure due to this and talking to gunsmiths, they felt it shouldn't be a problem. In fact, Holosun refers to them for their 407K as locating lugs, not recoil lugs. And, this quote from EGW validates my thoughts:
Quote:
Self centering screws with tapered heads act as recoil lugs and any inconsistency in spacing is worked out in the tolerances
Anyone else gotten a SCS yet?
Midway shows them as coming out on 8/7/22.
Ooof. That’s not quite end of May.
Just got my ship notice from EuroOptic.