Will a G decocker kit work with a .22 conversion kit?

Good afternoon,

I snagged one of the .22 top-end conversion kits earlier this year. I have it on an old Vertec frame, and it runs like a champ! :)

https://www.berettausa.com/en-us/ber...10-round-mag-/

I would like to change it over to a set of G decocker levers, so it matches my other two Vertecs.

Is this possible? If It's going to be unsafe or cause accelerated wear, I will obviously leave the original levers in place.

As an FYI, I swapped out the factory barrel for a threaded Beretta .22 barrel. It makes for a very sweet suppressed sub-caliber trainer.

https://www.berettausa.com/en-us/ber...readed-barrel/

Thanks in advance for any insight that is offered.

Quote:

---

Originally Posted by SeriousStudent

Good afternoon,

I snagged one of the .22 top-end conversion kits earlier this year. I have it on an old Vertec frame, and it runs like a champ! :)

https://www.berettausa.com/en-us/ber...10-round-mag-/

I would like to change it over to a set of G decocker levers, so it matches my other two Vertecs.

Is this possible? If It's going to be unsafe or cause accelerated wear, I will obviously leave the original levers in place.

As an FYI, I swapped out the factory barrel for a threaded Beretta .22 barrel. It makes for a very sweet suppressed sub-caliber trainer.

https://www.berettausa.com/en-us/ber...readed-barrel/

Thanks in advance for any insight that is offered.

---

Unfortunately it will not.

Thank you, Mr Stern. You just saved me 60 clams and a lot of frustration.

Have a great week, and thanks very much for the speedy response. :)

Quote:

---

Originally Posted by SeriousStudent

Thank you, Mr Stern. You just saved me 60 clams and a lot of frustration.

Have a great week, and thanks very much for the speedy response. :)

---

You got it. Sorry, that's been one of my white whales for a while. The .22 Kit just doesn't have enough room for a G variant decocker with the way it was developed. :/