Removing stripped and stuck RMR Torx screws?
I fucked up.
I was going to replace my MOS plate that was holding my RMR with a CHPWS plate. I put in a T8 Torx bit to the screw and turned. Snap! The tip of the bit sheared off into the screw! Fuck! When I installed it last, I used blue Loctite. I figured if I can heat the other screw up with an soldering iron, maybe I can get that off and somehow work on the other screw. After heating up the screw with the iron (did not give off impressive heat), I got a 2nd Torx bit and promptly broke the tip off that into the 2nd screw. Fuck me again! Any suggestions on un-fucking myself for this sad predicament?