Jb weld or loctite er on there...
Seriously though. This is not the first I have heard reports like this. Seems like most end up full circle back to direct mill setups.
Sent from my iPhone using Tapatalk
Printable View
Had an ugly match with my 320/509t using a custom CHPWS plate mounted by them. At first I thought it was me, but this thread made me want to check the plate mounting screws. I knew my shot calling wasn’t perfect, but a number of mikes on tuxedos were called hits....
Attachment 71612
EDIT- no visible thread locker residue and screw spun out freely. Other screw felt barely more than finger tight.
Those witness marks look familiar. Houston, we have a problem.
Just waiting on Loctite 248 for the Amazon fairy and I cleaned the threads with acetone. I’m hoping for success following mounting instructions from @SoCalDep
I'm guessing all of the above, but honestly I don't know. I'm going to use 248 and 15-20 in-lb and see what happens. Considering it took 5 months for CHPWS to produce/deliver the plate once they had my slide, it isn't going back to them.
Hey guys. Handled a 2.0 compact optics ready gun today. Seems nice and I want to try it out. Is it better to get a regular compact and mill it though?
I shoot glocks and know it’s much preferred to mill those but not sure if it’s the same with M&p’ sorry not?
The optics ready pistol is less costly to complete and gives you flexibility to switch optics. However I am not in love with the CORE system and the rear BUIS is like a knife.
My favorite Compact was direct milled for the RMR footprint with the rear BUIS in front of the optic.
Attachment 71898
I just bought my first CORE, mostly because I wanted to try a DPP which was my first non trijicon dot. It is working fine so far after a few practices & one match. It’s mounted with the Chpws plate.
If doing it all over I’d just mill, slides don’t cost that much and I kind of view them like brake pads.
I’m kinda torn. I know milling is the better option. But my dealer has the optics ready compact in stock as well has a 507C that I’d want to put on there. I can walk in there today and have it ready to go for like less than a grand.
Then, if I like it, I could get a regular 2.0 and have it milled. But I like how fast, easy, and cheap I could get set up with an M&p and optic to try out.
And then on a completely different idea I’ve been wanting a Staccato C2 optics ready but wait time is 3-4 months. I know of a retailer with the iron sighted C2 in stock so thought about getting that and then having it milled for the Chambers plate.