Oh shit!
Printable View
@ GJM,
What finish did you go with for your slide refinish from Primary Machine, I'm going to send a slide in to get milled for a Holosun.
Thanks
Steve
I had Wolff mill a g45 slide, they don’t mill in the posts, but it’s a sung fit for the optic.
Sent from my iPhone using Tapatalk
Sending off a G45 slide tomorrow to CHPWS for RMR cut and Zev posts. Excited to see the finished product.
507 direct mill with primary machine on a G45, standard height sights visible or must use suppressor height? Don't care if it's bottom 1/5, as long as usable.
507c will require suppressor height sights, 507k may allow for standard sights depending on how deep PM mills the slide.
I would strongly recommend finding the lowest possible BUIS. I want the bottom of the trough level with, or slightly below the top of the optic body. I think the Ameriglo's trapezoidal rear sight obscures the least.
For those sending slides to CHPWS, be prepared to wait longer than quoted.