As I'm sure you can tell by the fact that I liked your post, I'm deeply, deeply offended. :)
Printable View
I took a previously used Glock 19 JM CK shell from my last G19 (I think it is an IWB, 10 deg cant) and mocked up what I would like to have as a setup. This carries pretty well for me, standing, sitting etc. albeit obviously a little bit thicker than the G48 rig.
Attachment 73477
Custom order will be as follows, appreciate any feedback:
Shopping Cart
AIWB Holster - Wing Claw 2.5
Pistol: Glock 19 (Fits Gen 3/4/5)
Belt Loops: 1.5" DCC Monoblock
Carry Side: Left
Color: Orange $2.00
Discreet Carry Clips (DCC) Option: 1.5" Discreet Carry Clips $10.00
Guard: Full
Hole Pattern: Wide (only works with “Pull-the-Dot” loops)
Angular Muzzle Pad: None
Red Dot Sight Cut $5.00
Qty: 1
1) not sure how to specify the holster, is my problem, or I am confused, or both. Probably both.
This is what I want, except in lefty, cut for a dot, for a G19. What are the order options for this?
Attachment 73484
2) whelp that's how God made me. :)
Pretty sure that’s the standard hole spacing. I also don’t think you can get wide hole spacing with the red dot cut.
Jason
I have dual clips for my lwc wing claw 2.5 and I just put it right over the loop on some of the holsters. with one under belt and the other dug into the loop, I have never had an issue drawing the weapon. All pants are not created equal but these clips hold.